Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
first code won't run
#3
I just tested my hello triangle code with the very latest distro and it works fine, also with old and new libs on an upgraded distro SD, again works fine.
Most likely there is a typo somewhere in your make file created by your project properties, since it does not seem to be getting as far as a build.

if you can zip up your dir (excluding Debug/Release/obj  and VisualGDBCache dirs)  I can take a look at it 1st thing tomorrow and hopefully spot the error.

my email is brian@scratchpadgames.net
Brian Beuken
Lecturer in Game Programming at Breda University of Applied Sciences.
Author of The Fundamentals of C/C++ Game Programming: Using Target-based Development on SBC's 



Reply


Messages In This Thread
first code won't run - by pahendriks - 03-14-2018, 10:32 PM
RE: first code won't run - by Brian Beuken - 03-14-2018, 10:53 PM
RE: first code won't run - by Brian Beuken - 03-14-2018, 11:36 PM
RE: first code won't run - by pahendriks - 03-15-2018, 07:39 AM
RE: first code won't run - by Brian Beuken - 03-15-2018, 08:40 AM
RE: first code won't run - by pahendriks - 03-15-2018, 03:15 PM
RE: first code won't run - by Brian Beuken - 03-15-2018, 08:44 AM
RE: first code won't run - by Brian Beuken - 03-15-2018, 03:28 PM
RE: first code won't run - by pahendriks - 03-15-2018, 03:35 PM
RE: first code won't run - by Brian Beuken - 03-15-2018, 03:49 PM
RE: first code won't run - by sephris - 04-08-2018, 11:38 PM
RE: first code won't run - by Brian Beuken - 04-09-2018, 12:35 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)