Setting up Visual Studio and Raspberry Pi 400

[toyamigo]

   
Allrighty! 
Finally did it. It works. Had to do a 'Set as Startup Project', copy the headers to /usr/include and it showed up on my Pi.
Now I'll get a cup of coffee, deserved it. After that I can continue knowing things work ok.
Brian, thanks again for all the help. Good luck with settings things up there. 

[Brian Beuken]

That is awesome, well done, 1st steps

a small warning though... VNC is a great concept but.... it does create a few minor issues when it comes to timing,and accessing some hardware features, that may not matter a lot at this stage but later it can be a pain. Try to give the Pi it its own monitor .

[toyamigo]

That is awesome, well done, 1st steps

a small warning though... VNC is a great concept but.... it does create a few minor issues when it comes to timing,and accessing some hardware features,  that may not matter a lot at this stage but later it can be a pain. Try to give the Pi it its own monitor .

Thanks for the warning Brian, sounds fair enough..if you try to push every bit of your computer to run a program as it should and you access the Pi through a piece of software and the network you can get into troubles ;-)
For now it should work ok but later on I'll let the Pi run on its own, that can take a while though.
Have a great weekend!